Reverend Drivetrain Owner's Manual

Discontinued, no longer available.

Important Notes

• To prevent excessively loud initial switch "pops", pedal must be powered and plugged in (instrument cable inserted into IN jack) for at least 60 seconds before using. Repeat at the beginning of each playing session.
  

• Use of AC adapter will seriously damage pedal. Use only regulated 9VDC negative polarity adapter or 9V alkaline battery.
  

• Leave battery in pedal when using adapter or wrap battery plug with plastic bag to prevent terminals from shorting out inside pedal. Check battery periodically for fluid leakage if left in pedal for long periods of time.
  

• To extend battery life, unplug instrument cable from IN jack when not using pedal.
  

• The Drivetrain can be used to boost an already overdriven amp, to "push it over the top". This works best with the Drive control set at or below 60% on.

Drivetrain Warranty
Reverend pedals are covered by a one year limited warranty from date of purchase. Warranty covers defective workmanship or materials only. Warranty does not cover normal wear, or damage caused by misuse, abuse, modification, or acts of nature. Modification to product may void warranty. Warranty service must be preauthorized by Reverend, and performed by Reverend or an authorized Reverend service facility. If you have any questions concerning your Reverend pedal contact us at 586-775-1025.

Try the following sample settings into an amp set at a clean sound: